Flail - Forged Flail - Warlord and Force - Trimax Specification - [411-480-643]
$27.00
SKU
411-480-643
The forged flail blade for the Trimax Warlord S3 and Force S1 flail mowers. 114mm long, 16.5mm bore. Replace in full sets to maintain rotor balance.
-Select mower for quantities required and usage notes:
Compatible with the following mowers:
- Force - S1
- Warlord - S3
- Warlord - S3 LH
- Warlord - S3 RH
No spare parts instructions available for this product.
The forged replacement flail for the Trimax Warlord S3 and Force S1 flail mowers. At 114mm, this is a larger flail built for heavier vegetation. Replace as a complete set to keep the rotor balanced and reduce vibration on rotor bearings.
- 114 x 74 x 16.5mm forged steel
- Replace as a complete set to maintain rotor balance
- Genuine part. Maintains your Trimax warranty
Flails per mower
This table covers the most popular Trimax models. If your mower is not listed, check the cutting system section of your parts manual for the correct quantity.
| Mower | Width (cm) | Flails per mower |
|---|---|---|
| Warlord S3 | 175 | 24 |
| Warlord S3 | 205 | 28 |
| Warlord S3 | 235 | 32 |
| Force S1 | 115 | 16 |
| Force S1 | 145 | 20 |
| Force S1 | 175 | 24 |
| Force S1 | 205 | 28 |
| Force S1 | 235 | 32 |
Order at the same time
| Part | SKU | Quantity | Note |
|---|---|---|---|
| Hex Head Bolt M16 x 75 with Hex Nyloc Nut M16 - Trimax Specification | 306-216-705 | 1 per flail | The specified mounting bolt and nut for this flail. |
| Flail Mounting Bush - Trimax Specification - 10mm | 402-060-750 | 1 per flail (if worn or damaged) | On Warlord and Force, replace the bush only if worn or damaged, not at every flail change. |
| Nut - Plain M10 - Trimax Specification | 307-210-013 | 1 per flail | Replace the nyloc nut at every flail change. |